Airstream Caravanner 1977 Owner's Manual page 65

Fig. 1 -Lounge Into Bed
To convert the lounge into a bed,
lift up
the front of the lounge and fold down the
seat spacer bar located on the front edge
of the bed frame. Lower the lounge to
release the latch. Grasp the front edge of
the seat and pull lounge assembly out until
it stops. Lift the seat again until the lounge
back is in a horizontal position. Remove
stored bedding. Push release lever to the
left and lower the seat to a horizontal
position. Make sure that the bolster strip is
properly positioned before making bed.
To return bed to lounge position, grasp the
front edge of bed and raise until the pivot
pins engage to rear half of the bed. Store
bedding. Lower the seat to a horizontal
position, returning assembly to a lounge
position. Lift the front edge of seat and
swing seat spacer bar to up position.
Lower the seat and push lounge assembly
Fig. 2
toward the wall until locking pins engage.
The
below bed storage
is available on
fixed twin and double models for additional
storage of bedding and linen or fishing
and hunting gear. Both the front lounge and
the side roll-out lounge have below
bed storage.
A
space locker
attached to the roof
lockers is available for additional storage
space for bedding, etc. in the bedroom.
All the drawers are removable allowing you
storage flexibility and ease of packing and
unpacking. Wardrobe catches are self¬
locking and they may be opened by sliding
the touch plate away from the door
opening.
When attaching wall hung improvements,
like hooks for clothing, bookshelves and
extra towel racks, secure with half-inch
No, 8 sheet metal screws Dusartfr with flat
binder heads, make holes in the aluminum
inner walls with a small hand drill (No. 30
drill bit).
The
bunk beds
(optional), located in the
bedroom, serve as the bolster for the bed
when not in use. In order to place bunk into
sleeping position:
1. Depress latch located on the center
back side of the bolster.
2. With latch depressed pull up on fabric
loop located on the center front bottom
of bolster. This will allow bolster filler to
hinge down.
3. Bring bolster filler up to horizontal posi¬
tion and attach both straps onto bracket
on ceiling.
55