Table of Contents
Advertisement
Fig. 2- Window Operation
2) and place the operators into one of the
five positioning holes. To close: pull the two
side operator handles toward the center
and slowly lift.
The optional high strength safety glass
front center window
is cleaned in the
same manner that ordinary windows are.
Clean the seals with a damp cloth or mild
detergent every three to six months taking
care not to use strong solvents as they will
damage the seals. A coat of natural silicone
lubricant applied after the seal has dried
will keep it flexible. Spread the lubricant
evenly with a brush or finger, working it into
the surface. This is a good practice for all
rubber seals in your Airstream. For replace¬
ment of a damaged window contact an
Airstream Service Center or the factory.
The
optional double paned side windows
include metalized mylar tint. They eliminate
the need for storm windows and improve
the efficiency of the air conditioning system.
Screens
are made of plastic for hard wear
and easy maintenance. Clean with a damp
doth
Note: They will melt at the point of
contact if touched by a cigarette.
Vista view windows
are double paned,
allow for interior lighting while maintaining
privacy and are equipped with integral
shades.
Factory recommended awnings
give
shade during trips and rallies. They are
easy to operate and can be installed by
your dealer.
The aluminum construction of your trailer
creates a radio-shield and you will need
outside antennas for good reception.
This can be accomplished by a whip radio
antenna or T.V. antenna with an auto
coupler.
An
auto coupler
(optional) enables you to
utilize your T.V. antenna for AM-FM radio
reception.
A telescoping whip
radio antenna
(op¬
tional) is available for the optional 12-volt
AM-FM radio and should be professionally
installed next to the front window roadside
of your trailer on a swivel mount.
The controls for the optional
T.V. antenna
are in the ceiling directly below the
antenna. To raise the antenna, turn hand
crank clockwise until it stops. Then turn on
TV set and select channel. While watching
picture, reverse the handle approximately
V
2
turn, push handle up toward the ceiling,
hold in that position and rotate antenna. If
you hit a stop in rotation before the picture
is clear, reverse rotation. You may have to
readjust when changing channels. To close,
reverse the direction of cranking. Before
traveling, check outside that the antenna is
folded and pointed straight forward.
47
Advertisement
Table of Contents
