Table of Contents
Advertisement
Menu
DATA
NEW
EDIT
OPEN
DELETE ONE
GRID
DELETE ALL
GRID
UTIL
AUTO FIND
(UTILITIES)
SCAN MODE
ALARM
STATUS
ALARM HIGH
ALARM LOW
XFER
BACKUP
(TRANSFER)
SETUPS
RESTORE
SETUPS
BACKUP GRID
RESTORE
GRID
ABOUT
27
Function
Creates a new alpha numeric grid. You can customise the
grid file according to your requirements.
Modify the parameters of grid files previously saved.
Note: Predefined coordinates cannot be changed once they
have been created.
Recalls existing grids files from gauge memory.
Deletes a selected grid file from memory.
Deletes all files currently stored in memory.
Automatically
measurement is out of the viewable display area.
Enables a high speed scan mode that increases the overall
sample rate from 24 to 50 measurements per second,
depending on the current measurement mode used.
Toggles alarm mode ON, OFF, or AUDIBLE.
Sets the HI limit parameter. If the measurement exceeds
this value, a red light will illuminate and the alarm will
sound.
Sets the LOW limit parameter. If the measurement falls
below this value, a red light will illuminate and the alarm will
sound.
Allows you to backup the setups currently stored in your
gauge to a computer via the RS232 port.
Allows you to restore setups saved on a computer to your
gauge via the RS232 port.
Allows you to backup grids files stored in your gauge to a
computer via the RS232 port.
Allows you to restore grids files saved on a computer to
your gauge via the RS232 port.
Provides Elcometer NDT contact information and your
gauge software version.
Refer to the help section of your gauge NDT Link software
for a complete electronic manual covering data transfer.
Description
locates
the
detection
point
if
the
Advertisement
Table of Contents
