Figure 14. Using The Square Fastener; Figure 15. Apply Sensor To Patient - Nonin WristOx2 3150 Operator's Manual

5. Attach the sensor if it is not already connected (see "Attaching the Sensor").
6. Apply the sensor to the patient (figure 15). Refer to the sensor Instructions for Use for
proper sensor application sites and sensor application cautions and warnings.
7. When in Spot Check mode, inserting a finger in the sensor automatically turns the device
on. When the finger is removed, the device enters Standby mode in approximately 10
seconds.
NOTE: Depending on the sensor and ambient light conditions, it may take up to
3 minutes for the device to enter Standby mode.
8. If the device does not turn on, verify battery orientation, operation mode, and sensor
connection. Refer to "Troubleshooting" for additional information.
22
Figure 14: Using the Square Fastener
Figure 15: Apply Sensor to Patient
Using the WristOx Model 3150
2,