Operating Controller To Set Up The Network Connection With Camera; Controlling One Aw-He40 Camera Via Aw-Rp50 Controller; Serial Connection - Panasonic AW-HE40 Installation & Setup Manual

2．
Operating AW-RP50 Controller to Set Up the Network Connection with AW-HE40 Camera

【Controlling One AW-HE40 Camera via AW-RP50 Controller】

① Press MENU button. - (Fig. 1-A)
② Press [10] SYSTEM button. - (Fig. 1-B)
＊"[1] CAMERA CTL" will be displayed on the LCD screen. - (Fig. 2)
＊ If it is not displayed, turn F1 dial to make "[1] CAMERA CTL" appear.
③ While "[1] CAMERA CTL" is displayed on the LCD, press F1 dial. – (Fig. 1-C)
("[1] CAM1" will be displayed on the upper half, and the connection method (default: [NoAsign]) on the
lower half of the LCD screen.)
＊If it is not displayed, turn F1 dial to make [CAM1] appear.
【IP Connection】
④ Turn F2 dial to select [Network], then press F2 dial to determine the setting. – (Fig. 1-D)

【Serial Connection】

④ Turn F2 dial to select [Serial], then press F2 dial to determine the setting. – (Fig. 1-D)
(Figure 1: AW-RP50 Control Panel)
（A）
If the setting is executed correctly, the LED
marked with
status display lamp of the camera.
Status Display Lamp
〇
will light up according the
(Status Display Lamp ・・・ Shows the camera's power status)
(Figure 2: AW-RP50 LCD Panel)
MENU ON ⇒ Select [10]
（C）
［1］CAMERA CTL
（D）
Press F1
（B）
【IP Connection】
1.CAM1
【Serial Connection】
1.CAM1
Turn F2 to select ⇒ Press F2 to set
Lit in Green ・・・ Turned-On State
(Image is being output.)
Lit in Orange ・・・ Standby Mode (Factory Default)
Turning-on operation needs to be done.
Network
Serial