Turning Aw-He40 Camera On - Panasonic AW-HE40 Installation & Setup Manual

3．Turning AW-HE40 Camera On
★ Procedure for switching over from Standby (lit in orange) to Turned-On state (lit in green) on
the camera linked to "CAM1".
① Hold down the button [1]. – (Fig. 4-A) [POWER OFF] will be displayed on the LCD screen.
While the button [1] is held down, turn F2 dial – (Fig. 4-B) to change the setting to [POWER: ON], and
then press F2 dial. The camera will switch over to POWER ON mode (turned-on).
※ If the setting is changed to [POWER: OFF] while being in the turned-on state, the camera will switch
over to Standby mode.
(Figure 4: AW-RP50 Control Panel)
（A）
・
For details, please see the illustrated manual
AW-RP50".
――― This is the end of explanations of basic setting up. ―――
(AW-RP50 LCD Panel)
（B）
Hold down Button 1
CAM［1］ <AW-HE40>
POWER：OFF↓
Turn F2
(Turning ON)
CAM［1］ <AW-HE40>
POWER：ON↓
Press F2 to set
"Turning ON/OFF Remote Camera Using