The Configure Screen - ZyXEL Communications WAH7608 User Manual

About the WAH7608 Firewall
The WAH7608's firewall feature physically separates the LAN and the WAN and acts as a secure
gateway for all data passing between the networks.
It is a stateful inspection firewall and is designed to protect against Denial of Service attacks when
activated (click the Configure tab under Firewall and then click the Firewall Enable check box). The
WAH7608's purpose is to allow a private Local Area Network (LAN) to be securely connected to the
Internet. The WAH7608 can be used to prevent theft, destruction and modification of data, as well as
log events, which may be important to the security of your network.
The WAH7608 is installed between the LAN and a broadband modem connecting to the Internet. This
allows it to act as a secure gateway for all data passing between the Internet and the LAN.
The WAH7608 has one Ethernet WAN port and four Ethernet LAN ports, which are used to physically
separate the network into two areas.The WAN (Wide Area Network) port attaches to the broadband
(cable or DSL) modem to the Internet.
The LAN (Local Area Network) port attaches to a network of computers, which needs security from the
outside world. These computers will have access to Internet services such as e-mail, FTP and the World
Wide Web. However, "inbound access" is not allowed (by default) unless the remote host is authorized to
use a specific service.
Guidelines For Enhancing Security With Your Firewall
Change the default password via Web Configurator.
1
Think about access control before you connect to the network in any way, including attaching a
2
modem to the port.
Limit who can access your WAH7608.
3
Don't enable any local service (such as NTP) that you don't use. Any enabled service could present a
4
potential security risk. A determined hacker might be able to find creative ways to misuse the enabled
services to access the firewall or the network.
For local services that are enabled, protect against misuse. Protect by configuring the services to
5
communicate only with specific peers, and protect by configuring rules to block packets for the services
at specific interfaces.
Protect against IP spoofing by making sure the firewall is active.
6
Keep the firewall in a secured (locked) room.
7

10.2 The Configure Screen

Use this screen to enable or disable the WAH7608's firewall, and set up firewall logs. Click Configuration >
Security > Firewall to open the Configure screen.
Chapter 10 Firewall
WAH7608 User's Guide
78