Displaying Data On Scala - Marport M4 Service Manual

Note: Frequency Band: normal = 43600 kHz / high = 45000 kHz
Note: To deactivate Up sounding, enter 0 or deselect the check box.
5. On Scala receiver page, complete Quality settings according to the up and down settings:
UP
Yes
No
Yes
Yes/No
Important: *Displayed as Best in SC application.
6. Click Apply.
Results
The sensor is added to Marport receiver.

Displaying Data on Scala

About this task
Scala can only receive echogram data from the SC sensor. The other data (distance to bottom and
opening) are automatically measured by Scala.
Important: SC sensor has a blind zone of 1,4 m.
Procedure
1. SC sensor data appears under the name Trawl Explorer SC in the control panels, in Sensors
Data. To display the echogram:
a) Click Menu
b) Click + hold Range of Sonar Data and drag it to a page.
2. To have colors similar to an SC system:
a) Right-click the echogram and select Show Palettes.
b) Right-click each of the palette scales and select NC42ScanmarTrawleye.
DOWN
No
≤ 150 m
≤ 150 m
> 150 m
> Customize and enter the password eureka.
M4 System - 2 Mac Minis | V2 | Installation
Available quality settings on Scala
Worst / Medium / Best
Worst / Medium / Best
Worst / Medium*
Worst
| 69