Adding Temperature Data From The; Hydrophones To The System - Marport M6 PRO User Manual

Connect the extension cable of the junction box to a hydrophone input on the receiver:
• Connect to the NTC hydrophone input H1 or H2 to be able to receive water
temperature from Marport hydrophones.
Note: H3 hydrophone input allows to receive water temperature
from an NMEA connection (Scanmar hydrophone or NMEA converter
junction box). If you connect a Marport hydrophone to H3 without NMEA
converter, you will not have temperature data from the hydrophone.
the Hydrophones to the System
You can add the hydrophone to the receiver as a sensor in order to display in Scala2 the
temperature of the water surface.
Important: In order to receive temperature data, make sure the hydrophone
is connected to an NTC input on the receivers or is connected using an NMEA
converter junction box. See Connecting the Hydrophone to the Receiver (on
page 30) for guidelines.
1. From Scala2, click Menu
2. Right-click the IP address of the receiver at the bottom of the page, then click
Configure Receiver.
Adding Temperature Data from
> Expert Mode and enter the password
M6 PRO | V6 | Installation
.
copernic
31