Advertisement
Fiber Optic Ethernet Media Converter Kit
4
Install for an AUTODOME camera
To install the Fiber Optic Media Converter Module (VG4-SFPSCKT) inside a VG4 Power Supply
Box for an AUTODOME camera, complete the following steps.
1.
2.
3.
Figure 4.1: Locations of P106 and J103 sockets
4.
Bosch Security Systems
Turn off the power to the VG4 power supply box and remove the cover.
Remove the 6-pin connector from the P106 connector inside the power supply box, if
present.
Connect the supplied power harness (black) to the J103 socket on the power supply
board, located below the Heater connector.
Remove the rubber plug from the SFP module.
Installation Manual
Install for an AUTODOME camera | en
2016.07 | 2.0 | F.01U.134.924
9
P106
Advertisement
