Setup Preparation; Quick Setup - La Crosse Technology 327-1417BW Instructional Manual

Setup Preparation

Items you will need to setup your station (not included):
1. Phillips head screwdriver for assembly.
2. Fresh Batteries:
3 (three) AA alkaline batteries for the station
2 (two) C alkaline or lithium batteries for the Wind sensor.
For best results:
• Remove weather station and sensor from the package and place together on a table
or bench, within easy reach.
• Place batteries and screwdriver within reach of setup location.
• Keep sensor and weather station within 5-10 feet for at least 15 minutes after
installing batteries. This allows the sensors and station to sync properly and ensures a
strong connection.

Quick Setup

1. Power up: Insert 2-C batteries into the Wind/TH sensor. Then, insert 3-AA batteries
into the weather station.
2. Configure basic settings. Set Time, Date etc.
3. After 15 minutes, place sensor outside (see mounting instructions on
Wind Speed sensor
Red LED on sensor: The sensor has a red LED light that flashes once during each
sensor signal transmission.
327-1417BW
TX141Wv2
Wind Speed Weather Station
AA
AA
AA
Note: Batteries are
not included
page 14).
Weather Station
327-1417BW
Page | 3
Back
to
Top