Position Weather Station; Replace Wind Cups; Factory Reset/Clear Memory - La Crosse Technology 327-1417BW Instructional Manual

Position Weather Station

• Pull out the stand and place on a flat surface or use hanging holes on back of station
to wall mount.
1. Choose a location 6 feet or more away from electronics such as cordless phones,
gaming systems, televisions, microwaves, routers, etc.
2. Place within range of the outdoor sensors (330 ft, 100m open air).
3. Obstacles such as walls, windows, stucco, concrete, and large metal objects can
reduce the range.

Replace Wind Cups

1. Loosen the screw
2. Remove cups
3. Install new cups
4. Tighten screw
Note: The screw in the wind cups will fit snugly on the flat side of the metal stem on
the wind sensor.

Factory Reset/Clear Memory

1. Hold down both the WARNING and ALERTS button together for 5 second. This will
clear all recorded weather data and reset the station's settings back to default
2. The weather station will fully populate, clear all records, then return to a normal
display and search for outdoor sensors.
3. While searching for the outdoor sensor the Wind Speed and Outdoor Temp/Humidity
will show dashes.
4. Once connected to the outdoor sensor (allow 3 minutes) the Wind Speed and Outdoor
Temp/Humidity will show current readings.
5. In the absence of wind this reading will show 0.00.
Dashes = Not connected to sensor
0 or current readings = Connected to sensor.
327-1417BW
Flat Side Of
Stem Up
Wind Speed Weather Station
Insert and Attach
Flat End up
Page | 15
Back
to
Top