Table of Contents
Advertisement
1. Insert 2 AA batteries into your rain sensor. Observe correct polarity.
2. Insert 2 AA batteries into your rain station. Observe correct polarity.
3. Optional: Tip the rocker of your rain sensor to simulate rain and receive a reading
on your rain station.
4. Leave 5-10 feet apart for 15 minutes. After 15 minutes, with station and sensor
connected, move your rain sensor outside to an open area.
(Position Rain Sensor--
Rain Sensor:
• Flip down the locks on both sides of your rain sensor.
• Remove the funnel from the base to access the battery compartment.
• Flip up the lock on the side of the battery compartment to open.
• Insert 2-AA batteries according to polarity markings.
• Lock everything back into position.
Station:
• Remove the battery cover (under the pull out stand).
• Insert 2-AA batteries according to polarity markings.
T84237
Page
9)
Rocker
Base
www.lacrossetechnology.com/support/
Setup
Lock on
battery compartment
Funnel
Lock on base
A
A
A
A
Page | 2
Advertisement
Table of Contents
