Grandstream Networks GXV3370 Administration Manual page 41

SIP Timer D Interval
Remove OBP from
Route
Enable 100rel
Session Timing
Enable Session Timer
Session Expiration (s)
Min-SE (s)
UAC Specify Refresher
UAS Specify Refresher
Caller Request Timer
Defines the amount of time that the server transaction can remain when
unreliable response (3xx-6xx) received. The valid value is 0-64 seconds.
The default value is 0.
Configures the phone system to remove the outbound proxy URI from the
Route header. This is used for the SIP Extension to notify the SIP server
that the device is behind a NAT/Firewall. If it is set to "Yes", it will remove
the Route header from SIP requests. The default setting is "No".
Actives PRACK (Provisional Acknowledgment) method. PRACK improves
the network reliability by adding an acknowledgement system to the
provisional Responses (1xx). It is set to "Yes", the phone system will
response to the 1xx response from the remote party.
The default setting is "No".
Allows the phone system to use the session timer, when set to "Yes", it will
be added in the SIP INVITE message to notify the server.
Configures the phone system's SIP session timer. It enables SIP sessions
to be periodically "refreshed" via a SIP request (UPDATE, or re-INVITE).
If there is no refresh via an UPDATE or re-INVITE message, the session
will be terminated once the session interval expires. Session Expiration is
the time (in seconds) where the session is considered timed out, provided
no successful session refresh transaction occurs beforehand.
The default setting is 180. The valid range is from 90 to 64800.
Determines the minimum session expiration timer (in seconds) if the phone
act as a timer refresher.
The default setting is 90. The valid range is from 90 to 64800.
Sets which party will refresh the active session if the phone makes
outbound calls. If it is set to "UAC" and the remote party does not support
Refresher feature, the phone system will refresh the active session.
If it is set to "UAS", the remote party will refresh it. If it is set to "Omit", the
header will be omitted so that it can be selected by the negotiation
mechanism. The default setting is "Omit".
Specifies which party will refresh the active session if the phone receives
inbound calls. If it is set to "UAC", the remote party will refresh the active
session. If it is set to "UAS" and the remote party does not support refresh
feature, the phone system will refresh it.
The default setting is "UAC".
Sets the caller party to act as refresher by force. If set to "Yes" and both
party support session timers, the phone will enable the session timer
feature when it makes outbound calls. The SIP INVITE will include the
content "refresher=uac". The default setting is "No".
GXV3370 Administration Guide
Version 1.0.1.12
P a g e |
41