Enzo Power-Up; Locating The Enzo Ip Address - AMX NMX-MM-1000 Administrator's Manual

Enzo Power-up

When power is applied, the POWER LED on the front panel appears red and then blinks green while the device is booting. When the
device is finished booting and the device is ready for use, the LED remains solid green. The device usually takes 20-30 seconds to
boot. When booting is complete, the NMX-MM-1000 opens to the Enzo desktop (FIG. 16).
Enzo Desktop
FIG. 16

Locating the Enzo IP Address

On connection, a diagnostics screen can be accessed on which the IP address, Ethernet switch status, etc. can be viewed on the
connected video output. Perform the following steps to locate the IP address of the device. For further details on navigating the
Enzo interface, refer to the Enzo Users Guide.
1. On the Enzo opening screen, select Start New Session.
2. Press F12.
3. Select System Settings.
4. The IP address of the Enzo unit appears in the Device area (see FIG. 17) under the Device Info selection.
System Settings - Device Info Screen
FIG. 17
Administrators Guide - NMX-MM-1000 Enzo Meeting Presentation System
Installation
12