Installation; Overview; Mounting With An Nmx-Vrk V-Style Rack Shelf - AMX NMX-MM-1000 Administrator's Manual

Installation

Overview

Installing the NMX-MM-1000 is a quick and simple process. Before connecting the NMX-MM-1000 to its peripheral devices and
powering the device, be sure to mount the device using the desired method detailed below.
Installation
The NMX-MM-1000 can be mounted using an AVB-VSTYLE-RMK-1U V-Style Box Tray (FG1010-720/721). Consult the Mounting
Options for V Style Modules Quick Start Guide included with the kit for mounting instructions.
The Enzo also has rubber feet that can be applied to the bottom of the unit for table-top mounting.

Mounting with an NMX-VRK V-Style Rack Shelf

Enzo can be mounted in a rack by using an NMX-VRK V-Style Rack Shelf (FG3201-60). In addition to the Enzo, the PoE injector
module can be mounted on the rack shelf using cable ties to secure it to the provided tie down holes.
NMX-VRK V-Style Rack Shelf
FIG. 8
Perform these steps to mount the encoder using the NMX-VRK V-Style Rack Shelf:
1. Invert the Enzo and the rack shelf for ease of installation.
2. Attach the rack shelf to the bottom of the Enzo using the #4-40 3/16 inch undercut flat head screws (provided). Insert the
screws through the underside of the rack shelf and into the holes on the bottom of the Enzo. Note that only two screws are
required.
3. Install the rack shelf in a standard EIA 19 in. (48.26 cm) rack and secure with rack-mounting screws.
4. (This step is optional.) Attach fill plates using the #4-40 3/16 inch undercut flat head screws (provided). Be sure to use the
screw holes closest to the front of the tray.
5. Use wire ties (not provided) to mount the PoE injector to the rear section of the rack shelf. This step is optional.
Administrators Guide - NMX-MM-1000 Enzo Meeting Presentation System
Installation
8