Executing Rebuilding Manually - NEC Express5800/T120e Maintenance Guidance

Chapter 2 Useful Features
4.3.2

Executing rebuilding manually

Execute manual rebuilding when Auto Rebuild is set to "Off" (disables Auto Rebuild) in 4.2 Menu Tree.
Auto Rebuild is on (enables Auto Rebuild) by default. In this case, rebuilding is automatically executed after
a hard disk drive is replaced and therefore you do not need to execute rebuilding manually.
1. Replace the hard disk drive and turn on the server.
2. Run LSI Software RAID Configuration Utility.
3. Choose Rebuild from TOP Menu.
" Rebuild - PHYSICAL DRIVES SELECTION MENU" screen appears.
4. Move the cursor to a hard disk drive indicated by "FAIL", and then press <Space> key to select it.
The "FAIL" of the selected drive turns pink.
5. Press <F10> key after selecting the hard disk drive.
6. To start the rebuilding the selected drive, choose Yes at the confirmation message.
Rebuilding completes when the "Completed" progress bar on "REBUILDING" screen reaches 100%.
7. Press <Esc> key to return to TOP Menu, and then exit LSI Software RAID Configuration Utility.
Replace the hard disk drive
Run LSI Software RAID Configuration Utility
Execute rebuilding
Exit LSI Software RAID Configuration Utility
Rebuild – PHYSICAL DRIVES SELECTION MENU
PORT #
ONLINE A00-00
0
FAIL
1
Express5800/T120e Maintenance Guide
A00-01
4. RAID System Configuration
95