Reconnecting/Disconnecting Bluetooth - Sennheiser SDW 10 HS User Manual

14 ConneCtInG tHe BAse stAtIon
Pairing a headset via Bluetooth
1
Activate the pairing mode on your Bluetooth headset
(see the instruction manual of your device).
3
A
1s 1s 1s 1s
B
0.5s 0.5s 0.5s 0.5s
Press the button again to switch between pairing mode
for mobile phones
Clearing the list of previously paired devices
Press and hold the dongle's button for 3 seconds to enter pairing mode.
the LeD alternately flashes blue and red.
Double press the dongle's button.
the LeD flashes purple three times. the pairing list is cleared.

Reconnecting/disconnecting Bluetooth

SDW 5000 series headset system
<20 cm
A or headsets B.
3x
3x
2
"Pairing"
Press and hold the dongle's button for 3 seconds to
enter pairing mode.
the LeD alternately flashes blue and red.
4
once the Bluetooth devices are paired, the LeD flashes
3 times blue and then lights up in a constant dim blue.
to reconnect a Bluetooth device:
tap the dongle's button.
the LeD lights up blue once and after that flashes
3 times blue. the LeD is lit constantly in dim blue.
to disconnect a Bluetooth device:
2x
Double tap the dongle's button.
Bluetooth will be disconnected. the LeD flashes
3 times red. the dongle starts flashing blue and
searches for other Bluetooth devices.
Press & hold
3s
3x
"Connected"