Verifying The Queuing And Scheduling Configuration - Cisco Nexus 7000 Series Configuration Manual

Verifying the Queuing and Scheduling Configuration

Step 3
Step 4
Step 5
Verifying the Queuing and Scheduling Configuration
To display the queuing policy configuration, perform one of the following tasks:
Note The show commands display only the default policies that correspond to the active template.
Command
show queuing interface ethernet
show class-map type queuing
show policy-map type queuing
show policy-map system
show hardware qos dscp-to-queue
When you modify a network QoS template, remove queuing policies, if any, that are attached exclusively on
an F-Series module and M3 interface because these policies will be inconsistent with the new network QoS
template.
For more information about the fields in the output of these commands, see the Cisco Nexus 7000 Series
NX-OS Quality of Service Command Reference document.
Cisco Nexus 7000 Series NX-OS Quality of Service Configuration Guide
130
Command or Action
(Optional) switch(config)# hardware module
module-number port-group port-group-number
(Optional) switch(config-port-group)# qos
shared-buffer queue-limit percent
(Optional) switch(config)# copy
running-config startup-config
Configuring Queuing and Scheduling on F-Series I/O Modules
Purpose
Enters the configuration for the specified port
group on the module. If you want to change the
default queue limit ratio, you do it by port group
on the specified module.
Sets the queue limit for the shared buffer queue
for the specified port group. The range is from
10 to 80 percent.
Note The total queue limit for all the
queues in the policy cannot exceed
100.
Saves the running configuration to the startup
configuration.
Purpose
Displays information about whether the queuing
policy is applied correctly to the module.
Displays information about all configured class maps
or a selected class map of type queuing.
Displays information about all configured policy maps
or a selected policy map of type queuing.
Displays information about the network qos and
queuing policy-maps that are currently in effect on
the system.
Shows the status of DSCP queuing.