Configuring Ingress Buffer Policy; Configuring Egress Queue Bandwidth Allocation - Cisco Nexus 7000 Series Configuration Manual

Configuring Ingress Buffer Policy

Step 2
Step 3
Step 4
Step 5
Configuring Ingress Buffer Policy
Procedure
Step 1
Step 2
Step 3
Step 4
Step 5

Configuring Egress Queue Bandwidth Allocation

Procedure
Step 1
Cisco Nexus 7000 Series NX-OS Quality of Service Configuration Guide
84
Command or Action
switch(config)# class-map type queuing
{system-pq1 | system-q-default | system-q2 |
system-q3}
switch(config-cmap-que)# match cos
value-range
switch(config-cmap-que)# exit
Command or Action
switch# configure terminal
switch(config)# policy-map type queuing
ingress-policy-name
switch(config-pmap-sys)# class type queuing
system-q-default
switch(config-pmap-c-sys)# queue-limit
{default | burst-optimized | mesh-optimized
| percent percent_of_queuelimit}
switch(config-pmap-c-sys)# exit
Command or Action
switch# configure terminal
Configuring Fabric QoS Mapping
Purpose
Configures the class map of type queuing,
specifies the class map name as the selected
system-defined queue and then enters class-map
queuing mode.
Sets the CoS value range matched by this queue.
You can specify a range of values by using a
hyphen between the beginning and ending
values and a comma between values. The range
is from 0 to 7.
Exits class-map queue mode and enters global
configuration mode.
Repeat Steps 2 to 4 to configure additional
system-defined queues
Purpose
Enters global configuration mode.
Configures the policy map of type queuing with
the user-defined ingress policy and enters
policy-map mode.
Specifies the class type queue as
system-q-default and enters policy-map class
system mode.
Configures the queue limit for the system queue.
Exits policy-map class system mode and enters
global configuration mode.
Purpose
Enters global configuration mode.