Configuring Fabric Qos Mapping; Copying A Default Policy; Configuring Cos2Q Fabric Mapping - Cisco Nexus 7000 Series Configuration Manual

Configuring Fabric QoS Mapping

Configuring Fabric QoS Mapping
User-defined Fabric QoS Mapping is configured in the following sequence:
• Copying a default policy to create a user-defined policy for fabric mapping

• Configuring cos2q fabric mapping

• Configuring ingress buffer policy for fabric mapping
• Configuring egress buffer queue bandwidth allocation for fabric mapping
• Configuring the new policy on fabric
You can copy a default policy to create a new policy for fabric mapping and modify the QoS configuration.
If a user-defined policy is not applied on fabric, the default policies will be considered in ingress and egress
directions.
Note
Only the users who have access to the default VDC or the admin VDC can copy the default policy and modify
the default fabric QoS configuration on the copied policy.

Copying a Default Policy

Procedure
Step 1
Step 2
Step 3
Configuring Cos2q Fabric Mapping
Procedure
Step 1
Command or Action
switch# configure terminal
switch(config)# qos copy policy-map type
fabric-queuing system-in-policy {prefix |
suffix} prefix-or-suffix-name
switch(config)# qos copy policy-map type
fabric-queuing system-out-policy {prefix |
suffix} prefix-or-suffix-name
Command or Action
switch# configure terminal
Cisco Nexus 7000 Series NX-OS Quality of Service Configuration Guide
Configuring Fabric QoS Mapping
Purpose
Enters global configuration mode.
Copies the default input policy to create a user
defined input policy with the specified prefix
or suffix.
Copies the default output policy to create a user
defined output policy with the specified prefix
or suffix.
Purpose
Enters global configuration mode.
83