Tektronix PHASER 840 Service Manual page 59

Error code
Additional clues
2. More than one sheet in
duplex path
3. Media is from lower
feeder and has small left
margin
4. Stiff media
22,541.05 Unexpected right width sensor (A/A4 sensor) event *** Same as 22,511.02
***
22,542.17 Time-out on preheat exit sensor (duplex). Unexpected duplex sensor event
*** Same as 22,512.14 ***
22,548.03 Duplex long declaration determined from duplex sensor
1. More than one sheet in
duplex path
22,600.01 Command stop event with media in exit cover area *** See SF144 ***
1. Media perfect in media
path (exit door area)
22,601.02 Unexpected Lower-tray-present-sensor event in Lower Feeder 2 with
media in the exit door area *** Same as 22,101.06 ***
22,603.04 Unexpected Lower-tray-present-sensor event in Lower Feeder 1 with
media in the exit door area *** Same as 22,101.06 ***
22,605.05 Unexpected standard-tray-sensor event with media in exit door area ***
Same as 22,105.01 ***
22,614.06 Unexpected duplex-sensor event *** Same as 22,514.05 ***
22,638.14 Time-out on preheat-exit sensor (duplex) with media in exit cover
1. More than one sheet of
paper in path
48
Phaser 840 and 850 Color Printers
Probable cause
a. Media was pulled from
exit into duplex while
printing
b. Multiple pick
a. Lower feeder bias
problem
a. Can't turn corner form
paper tray to drum
a. Media was pulled from
exit into duplex while
printing
b. Multiple pick
a. Drum maintenance
clutch
b. PostScript fault
c. Front panel error
d. Power supply problem
a. Media was pulled from
exit into duplex while
printing
a. Multiple pick
Action
a. Empty exit tray
b. Retry
b. Make sure media is
flush with the left side of
the tray
b. Run lighter media
(< 32#)
a. Empty exit bin
b. Retry
a. Replace the drum
maintenance clutch
b. Try again, cycle power,
or NVRAM reset
c. Replace front panel
assembly
d. Replace power supply
a. Empty exit
b. Run again