Cleaning And Troubleshooting Your Waterpik; Water Flosser - Waterpik WP-950 Instruction Manual

8

CLEANING AND TROUBLESHOOTING YOUR WATERPIK

Using Mouthwash and Other Solutions
Your Waterpik Water Flosser can be used to deliver
®
mouthwash and antibacterial solutions. After using
any special solution, rinse unit to prevent clogging by
partially filling reservoir with warm water and running
unit with tip pointed into sink until unit is empty.
Cleaning
Before cleaning, unplug from the electrical outlet.
Clean the product when necessary by using a soft
cloth and mild non-abrasive cleanser.
The accessory storage container and the water
reservoir are removable for easy cleaning and are
top rack dishwasher safe.
Removing Hard Water Deposits
Hard water deposits may build up in your unit,
depending on the mineral content of your water.
If left unattended, it can hinder performance.
Cleaning internal parts: add 2 tablespoons of
white vinegar to a full reservoir of warm water.
Point the handle and tip into sink. Turn unit ON
and run until reservoir is empty. Rinse by repeating
with a full reservoir of clean warm water.
This process should be done every 1 to 3 months
to ensure optimal performance.
Leakage
If leaking due to a damaged hose, replacement hoses
and handles can be purchased at www.waterpik.com
or contact Water Pik Inc. customer service for a self
service repair kit.
Excess Power Cord Storage
After determining the length
of power cord necessary,
push extra cord into the
cavity on the bottom of the
unit and insert cord into the
retention slots.
Service Maintenance
Waterpik Water Flossers have no consumer-
®
serviceable electrical items and do not require routine
service maintenance. For all accessories go to
www.waterpik.com.
You may also call our toll-free customer service
number at 1-800-525-2774.
Refer to the serial and model numbers in all
correspondence. These numbers are located on the
bottom of your unit.
Still have questions? Go to www.waterpik.com.

WATER FLOSSER

®