Care Of Your Waterpik® Sensonic® Professional Toothbrush - Waterpik Sensonic Professional Toothbrush Instructions Manual

10
CARE OF YOUR WATERPIK® SENSONIC® PROFESSIONAL TOOTHBRUSH
1. After each use, turn off unit, remove the brush
head from the handle and rinse brush head
under water.
2. Wipe the handle dry after each use.
3. Periodically, clean the charger base by
unplugging the unit and wiping with a damp cloth.
Service
There is no required routine service maintenance
and this product cannot be repaired.
For all your warranty and accessory needs, please
visit www.waterpik.com/intl. Please do not ship
product to Waterpik International, Inc. offices,
this will delay service. Refer to serial number
and model number in all correspondence. These
numbers are located on the bottom of your unit.
To locate your local distributor, go to
www.waterpik.com/intl.
Battery Disposal
The unit contains a Nickel Metal Hydride battery.
At the end of the battery life, please recycle
the unit at your nearest recycle center per
local or state requirements. The battery is not
replaceable. Batteries are permanently installed
for performance reasons and are not removable
for service or replacement. Batteries may be
removed for recycling by dismantling the unit.
Important Precautions
Using Arm & Hammer
®
abrasive or chemical cleaners may damage the
plastic housing of this product. Use of these
products voids this product warranty.
PeroxiCare toothpaste,
®