Advertisement
Water Flosser
TIPS
NOT ALL TIPS INCLUDED IN ALL MODELS
*Replace Every 3 months
** Replace Every 6 months
Sonic/Oscillating Toothbrush
Brush Heads
*Replace Every 3 months
NOTE: BRUSH HEADS ARE NOT INTERCHANGEABLE.
EACH UNIT ONLY CONTAINS ONE TYPE OF TOOTHBRUSH.
Replacement tips/attachments may be purchased online at www.waterpik.com or by phone from Water Pik, Inc. at 1-800-525-2774. To find detailed information about tips, other accessories, and product usage please visit our website at www.waterpik.com.
Powering the Unit
Plug the cord into an electrical outlet. If the outlet is controlled by a wall switch, be sure it is turned on.
Preparing the Reservoir
Lift the reservoir lid, remove the reservoir, and fill with lukewarm water. Replace the reservoir over the base and press down firmly and close the lid.
Inserting and Removing Tips
Insert tip into the center of the Water Flosser handle, pressing down firmly until tip clicks into place. The colored ring will be flush with the top of the handle if the tip is correctly locked into place.
To remove tip from the handle, slide the tip eject button on the handle.
Do not use tip eject slide while unit is running.
Prime Unit (First Time Use Only)
Set pressure control dial on base to high (pressure setting No. 10), point the handle and tip into sink. Turn unit ON (l) and water ON until water flows from the tip. Turn Power Of (O).
Adjusting the Pressure Setting
Turn the pressure control dial on the base of the unit to the lowest setting (pressure setting No. 1) for first-time use. Gradually increase pressure over time to the setting you prefer – or as instructed by your dental professional.
Using the Water Flosser
Always place the tip in your mouth before turning the water ON. With water switch in OFF position, turn power on. Lean over sink and slightly close lips enough to prevent splashing while still allowing water to flow from mouth into the sink. Turn water switch ON. When finished, turn water switch and power OFF. During use you can stop the flow of water by sliding the water switch on handle to the OFF position.
NOTE: Motor will continue to run.
Recommended Technique
For best results, start with the back teeth and work toward the front teeth. Glide tip along gumline and pause briefly between teeth. Continue until you have cleaned the inside and outside of both the upper and lower teeth.
When Finished
Turn the unit OFF (O). Empty any liquid left in the reservoir. Unplug the unit.
NOTE: If you used mouthwash or other solution besides water, see "Using Mouthwash and Other Solutions" section.
NOTE: NOT ALL TIPS INCLUDED WITH ALL MODELS.
TIP USAGE
Plaque Seeker™ Tip
To use the Plaque Seeker™ tip, place the tip close to the teeth so that the bristles are gently touching the teeth. Gently glide tip along gumline, pausing briefly between teeth to gently brush and allow the water to flow between the teeth.
Orthodontic Tip
To use the orthodontic tip, gently glide tip along gumline, pausing briefly to lightly brush area between teeth and all around orthodontic bracket, before proceeding to the next tooth.
Pik Pocket™ Tip
The Pik Pocket™ tip is specifically designed to deliver water or anti-bacterial solutions deep into periodontal pockets.
To use the Pik Pocket™ tip, set the unit to the lowest pressure setting. Place the soft tip against a tooth at a 45-degree angle and gently place the tip under the gumline, into the pocket.
Tongue Cleaner Tip
Set to lowest pressure setting, place tip in the center/middle of your tongue about half way back. Pull forward with light pressure. Increase pressure as you prefer.
Using Mouthwash and Other Solutions
Your Waterpik® Water Flosser can be used to deliver mouthwash and antibacterial solutions. After using any special solution, rinse unit to prevent clogging by partially filling reservoir with warm water and running unit with tip pointed into sink until unit is empty.
Cleaning
Before cleaning, unplug from the electrical outlet. Clean the product when necessary by using a soft cloth and mild non-abrasive cleanser. The water reservoir is removable for easy cleaning and is top rack dishwasher safe.
Removing Hard Water Deposits / General Cleaning
Hard water deposits may build up in your unit, depending on the mineral content of your water. If left unattended, it can hinder performance. Cleaning internal parts: add 2 tablespoons of white vinegar to a full reservoir of warm water. Point the handle and tip into sink. Turn unit ON and run until reservoir is empty. Rinse by repeating with a full reservoir of clean warm water.
This process should be done every 1 to 3 months to ensure optimal performance.
Leakage
If leaking due to a damaged hose, replacement hoses and handles can be purchased at www.waterpik.com or contact Water Pik Inc. customer service for a self service repair kit.
Service Maintenance
Waterpik® Water Flossers have no consumer serviceable electrical items and do not require routine service maintenance. For all accessories go to www.waterpik.com. You may also call our toll-free customer service number at 1-800-525-2774 (USA) or 1-888-226-3042 (Canada). Refer to the serial and model numbers in all correspondence. These numbers are located on the bottom of your unit.
Still have questions? Go to www.waterpik.com.
Charging the Triple Sonic Toothbrush
Charge for 24 hours before frst use. All 3 charge indicator lights will stay on continuously when the unit is fully charged. A full charge will last for approximately 1 week of typical use (2 minutes of brushing twice a day).
If the toothbrush is to be stored for an extended period of time (six months or more), be sure to fully charge it prior to storage.
Recharge Indicator Lights
Charge indicator lights will indicate level of battery charge for approximately 10 seconds after use and after removal from the charging base, and will then turn of.
Fully Charged
2/3 Charged
1/3 Charge Life (Recharging is Recommended)
Unit will not operate if the bottom LED begins to blink rapidly.
In order for the toothbrush to begin to work again, it must be placed on the charger for approximately 1 hour.
Modes
Clean: Standard mode for superior teeth cleaning.
Whiten: Teeth cleaning with polishing and whitening.
Massage: Pulsates for gentle gum stimulation.
Sonic brushing
Charging the Triple Clean Toothbrush
Charge for 24 hours before first use. When the toothbrush is fully charged, the charge indicator will be green while sitting on the base. A full charge will last for approximately 1 week of typical use (2 minutes of brushing twice a day).
If the toothbrush is to be stored for an extended period of time (six months or more), be sure to fully charge it prior to storage.
Recharge Indicator Lights
Charge indicator lights will indicate level of battery charge for approximately 10 seconds after use and after removal from the charging base, and will then turn of.
Fully Charged– CHARGE light is green.
2/3 Charged – Both MASSAGE and LOW lights are flashing green.
1/3 Charge life – MASSAGE light is green. Recharging is recommended.
NOTE: If the charger light blinks red and green when of the charger base, the unit has a low battery level and may not operate.
In order for the toothbrush to begin to work again, it must be placed on the charger for approximately 1 hour.
Modes
High: Everyday cleaning performance
Low: Gentle movements for effective cleaning of sensitive teeth
Massage: Micro-pulse pattern for enhanced gum stimulation
Brushing
Cleaning
Service Maintenance
Waterpik® Toothbrushes have no consumer serviceable electrical items and do not require routine service maintenance. For all accessories go towww.waterpik.com. You may also call our toll-free customer service number at 1-800-525-2774 (USA) or 1-888-226-3042 (Canada). Refer to the serial and model numbers in all correspondence. These numbers are located on the bottom of your unit.
Still have questions? Go to www.waterpik.com.
Note: This process is not reversible
Remove the battery only at the end of the product's life for recycling. Doing so earlier will destroy the product. Deplete the battery charge until the brush no longer operates. Observe basic safety precautions.
Remove the batteries as shown and recycle them and the rest of the product according to local regulations.
READ ALL INSTRUCTIONS BEFORE USING.
To reduce the risk of electrocution:
To reduce the risk of burns, electrocution, fire, or injury to persons:
SAVE THESE INSTRUCTIONS
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Download Waterpik Complete Care 9.0 - Electric Toothbrush with Water Flosser Manual
Advertisement
Thank you! Your question has been received!
Need Assistance?
Do you have a question about the Complete Care 9.0 that isn't answered in the manual? Leave your question here.