ADJ PAR Z100 5K User Instructions page 10

SYSTEM MENU (continued)
- In this menu you are able to make gamma corrections.
1. Press the MENU button until is displayed, press ENTER.
2. Use the UP or DOWN buttons to gamma corrections.
3. Once you have found your desired dimming frequency press ENTER to confirm.
- This function will reverse the display 180º.
1. Press the either the MENU button until is displayed, press ENTER.
2. Press the UP button to select "DSIP" to "flip" the display, or "DISP" to revert the display to normal.
3. Press ENTER to confirm.
- This function will allow you to manually adjust each brightness, fine dimming, and
strobing. Fine dimming and strobing are only used with 3 channel mode.
1. Press the MENU button until is displayed, press ENTER.
2. Use the UP and DOWN buttons to scroll through the settings. Once you have found your desired function
you would like to adjust press ENTER.
3. After you have pressed ENTER, use the UP and DOWN buttons to adjust the values. Once you have made
your adjustments press ENTER to set them. Press the MENU button to exit.
- This function will run a self test program.
1. Press the MENU button until is displayed, press ENTER.
2. The fixture will now run a self test. Press the MENU button to exit and quit the self test.
- With this function you can check the temperature of the fixture.
1. Press the MENU button until is displayed, press ENTER.
2. The fixture temperature will now be displayed. Press MENU to exit.
- With this function you can display the running time of the unit.
1. Press the MENU button until is displayed, press ENTER.
2. The running time of the fixture will now be displayed. Press MENU to exit.
- Use this function to display the Software version of the unit.
1. Press the either the MENU button until is displayed, press ENTER.
2. The display will show the software version.
A.D.J. Supply Europe B.V. – www.adj.eu – Par Z100 5K Instruction Manual Page 10