ADJ PAR Z100 5K User Instructions page 9

SYSTEM MENU (continued)
System Menu: When making adjustments press ENTER to confirm your setup then press and hold the
MENU button for at least 3 seconds. To exit without making any adjustments press the MENU button.
The display will lock after 30 seconds, press the MENU button for 3 seconds to unlock.
- DMX Address Setting.
1. Press the either the MENU, UP, or DOWN buttons until
2. The current address will now be displayed and flashing. Press the UP or DOWN buttons to find your desired
address. Press ENTER to set your desired DMX address.
- This will let select your desired DMX channel mode.
1.Press the either the MENU button until
mode will be displayed.
2.Press the UP or DOWN buttons to find your desired DMX channel mode and press ENTER to confirm and
exit.
- This mode can be used as a precaution mode, that in case the DMX signal is lost,
interrupted, or power is lost, the operating mode chosen in the setup is the running mode the fixture
will go into when the DMX signal is lost. You can also set this as the operating mode you would like
the unit to return to when power is applied.
1. Press the MENU button until
beneath.
2. Press ENTER and the bottom choice will begin to flash. Use the UP or DOWN buttons to choose an
operating mode you would like the unit to start up in when power is applied or the DMX signal is lost.
•BLND (Blackout) - If the DMX signal is lost or interrupted, the unit will automatically go into stand by mode.
•HOLD - If the DMX signal is lost the fixture will stay in the last DMX setting. If power is applied and this mode
is set, the unit will automatically go into the last DMX set up.
3. Press ENTER to confirm your desired set up.
- This will let select your desired dimmer curve.
1. Press the MENU button until
displayed. "STDA" (standard), "STGE" (stage), "TV" (TV), "ARAL" (Architectural), "THAL" (Theatre), or (Stage
2). See the dimmer curve chart on page 13 for more info.
2. Press the UP or DOWN buttons to find your desired dimmer curve and press ENTER to confirm and exit.
- With this function you can adjust the dimming frequency.
1. Press the MENU button until
2. Use the UP or DOWN buttons to adjust the dimming frequency between 900hz, 1000hz, 1100hz, 1200hz,
1300hz,1400hz, 1500hz, 2500hz, 4000hz, 5000hz, 10000hz, 15000hz,20000hz, or 250000hz.
3. Once you have found your desired dimming frequency press ENTER to confirm.
is displayed, and either "BLND" or "HOLD" will be displayed
is displayed, and press ENTER. 1 of 6 dimmer curves will be
is displayed, press ENTER.
A.D.J. Supply Europe B.V. – www.adj.eu – Par Z100 5K Instruction Manual Page 9
is displayed, press ENTER.
is displayed, press ENTER. The current DMX channel