Module/Channel Parameters - Siemens SIMATIC ET 200SP HA Manual

Parameters

4.2 Module/channel parameters

4.2 Module/channel parameters
Parameters of the DI 16xNAMUR HA
You have the following setting options:
Table 4-1 Parameters and their default settings
Parameters
Diagnostics,
Missing supply voltage L
+
IO redundancy
Diagnostics
Short-circuit
Diagnostic
Wire break
Diagnostic
Change-over contact er‐
ror
Diagnostic
Flutter error
Flutter monitoring: Moni‐
toring window
Flutter monitoring: Num‐
ber of signal changes
Hardware interrupts
Encoder type
16
Value range
● Enabled
● Disabled
● None
● 2 modules
● Enabled
● Disabled
● Enabled
● Disabled
● Enabled
● Disabled
● Enabled
● Disabled
● 0.5 s
● 1 s to 100 s (can be set in
1 s-increments)
● Disabled
● 2 to 32
● Disabled
● Rising edge
● Falling edge
● Falling and rising edge
● Channel disabled
● NAMUR sensor
● Single contact,
unconnected
● Single contact, connected
with 10 kΩ
● NAMUR change-over
contact
● Change-over contact,
unconnected
● Change-over contact,
connected with 10 kΩ
Default Changing parameter
settings in RUN
Enabled Yes
None Yes
Enabled Yes
Enabled Yes
Disabled Yes
Disabled Yes
0.5 s Yes
Disabled Yes
Disabled Yes
NAMUR sensor Yes
Digital Input Module DI 16xNAMUR HA (6DL1131-6TH00-0PH1)
Efficiency range
Module
Module
Channel
Channel
Channel
Channel
Channel
Channel
Channel
Channel
Manual, 11/2017, A5E39293880-AB