Parameter Assignment; A.2 Parameter Assignment - Siemens SIMATIC ET 200SP HA Manual

A.2

Parameter assignment

Parameter assignment in the user program
You can reconfigure individual channels of the module in RUN without this having an effect
on the other channels.
Changing parameters in RUN
The "WRREC" instruction is used to transfer the parameters to the module using data
record 128. The parameters assigned with STEP 7 are not changed permanently in the CPU,
which means the parameters assigned with STEP 7 are valid again after a restart.
Output parameter STATUS
If errors occur when transferring parameters with the "WRREC" instruction, the module
continues operation with the previous parameter assignment. The STATUS output parameter
contains the corresponding error code.
The STATUS output parameter is 4 bytes long and is configured as followed:
● Byte1: Function_Num, general error code
● Byte2: Error_Decode, location of the error code
● Byte3: Error_Code_1, error code
● Byte4: Error_Code_2, manufacturer-specific extension of the error code
Module-specific errors are displayed via Error_Decode = 0x80 and Error_Code_1 /
Error_Code_2.
Error_ Error_ Cause
Code_ Code_
1 2
0xB0 0x00 Number of the data record unknown
0xB1 0x01 Length of the data record is incorrect
0xB2 Varia‐ Module cannot be reached
ble
0xE0 0x01 Wrong version in the header
0xE0 0x02 Header error (number or length of parameter block) Correct the length and number of the parameter
Digital Input Module DI 16xNAMUR HA (6DL1131-6TH00-0PH1)
Manual, 11/2017, A5E39293880-AB
Drivers, parameters, diagnostics messages and address space
Remedy
Enter valid number for data record.
Enter valid value for data record length.
● Check station - is the module plugged in
correctly?
● Check the parameters of the WRREC
instruction.
Correct the version number of the parameter block.
blocks.

A.2 Parameter assignment

37