6. Hardware spec. of CAN connection
6.1. Appearance
The CAN connection for DT10 needs LAWICEL CANUSB (http://www.canusb.com/).
DynamicTracer is NOT used.
6.2. Communication spec.
・ Supports the CAN2.0A standard format (11Bit_ID) and CAN2.0Bextended format (29Bit_ID).
・ Supported baud rates: 10 / 20 / 50 / 100 / 250 / 500 / 800K / 1M bps ( Select one of them on PC application )
6.3. How to connect
・ Connect CANUSB and PC via USB2.0
・ Connect CANUSB and target board by D-SUB 9pin Connector.
Download the CANUSB Direct Driver (D2XX) from LAEICEL's website at
http://www.canusb.com/
Caution
Ensure your PC recognizes CANUSB before starting to use DT10.
Copyright © 2012-2014 Heartland. Data Inc.
and install it.
- 23 -
DT10 Hardware Manual