Spi Connection Spec - Heartland DT10 Hardware Manual

2.6.2. SPI connection spec.

An 8pin probe is needed for the SPI connection. Refer to the next table and connect the 8pin probe to the target.
Pins used for SPI connection
No. Name
1 GND
2 CLK
3 CS
4 DOUT
5 DAT0
6 DAT1
7 DAT2
8 DAT3
How to insert the probe
A
▼
プローブの１ピン（黒の配線）が、
The probe's 1PIN (black cable)
Cコネクタの▼の位置側に
なる様に挿入。
and the mark of the
C-connector are matched and
inserted.
Copyright © 2012-2014 Heartland. Data Inc.
Description
Connect to the target GND
Connect to the CLK output pin
Connect to the CS output pin
For write data output
Connect to the DAT0 output pin
Unused
Unused
Unused
C
▼
▼
プローブのコネクタ
Probe's connector
* Never insert the 8PIN cable and
※8ピンプローブと、FPCケーブルは、
B
同時に挿入しないで下さい。
FPC cable at the same time.
- 9 -
DT10 Hardware Manual