Analog Signal Input Spec - Heartland DT10 Hardware Manual

5.4. Analog signal input spec.

When you input the analog signal, input the signal to the analog input terminal or BNC connector.
The GND of the analog input must connect to the GND for an analog signal.
The 2ch analog input can be input at once.
The range can be selected according to the analog signal using a range selector switch.
Pins used for analog input
Terminal Name
AGND
A1
A1 (BNC connector)
A2
A2 (BNC connector)
Spec. of analog input
Resolution of the analog signal
Sampling frequency
Maximum input voltage
Copyright © 2012-2014 Heartland. Data Inc.
Description
GND for the analog signal input
Input for the A1 signal
Input for the A1 signal
Input for the A2 signal
Input for the A2 signal
Name MIN. TYP.
256
1
- 22 -
DT10 Hardware Manual
MAX. UNIT
bit
MHz
24 V