Gpio Connection Spec - Heartland DT10 Hardware Manual

2.5.2. GPIO connection spec.

An 8pin probe is needed for GPIO connections. Refer to the following table and connect the 8pin probe to the target.
Pins used for GPIO connections
No. Name
1 GND
2 CLK
3 CS
4 DOUT
5 DAT0
6 DAT1
7 DAT2
8 DAT3
How to insert the probe
A
▼
プローブの１ピン（黒の配線）が、
The probe's 1PIN (black cable)
Cコネクタの▼の位置側に
なる様に挿入。
and the mark of the
C-connector are matched and
inserted.
Copyright © 2012-2014 Heartland. Data Inc.
Description (4bit)
Connect to the target GND
Connect to the CLK output pin
Connect to the CS output pin
For write data output
Connect to the DAT0 output pin
Connect to the DAT1 output pin
Connect to the DAT2 output pin
Connect to the DAT3 output pin
C
▼
▼
プローブのコネクタ
Probe's connector
- 6 -
Connect to the target GND
Connect to the CLK output pin
Connect to the CS output pin
For write data output
Connect to the DAT0 output pin
Connect to the DAT1 output pin
※8ピンプローブと、FPCケーブルは、
B
* Never insert the 8PIN cable and
同時に挿入しないで下さい。
FPC cable at the same time.
DT10 Hardware Manual
Description (2bit)
Unused
Unused