Logic Signal Input Spec - Heartland DT10 Hardware Manual

5.3. Logic signal input spec.

The attached probe is needed for the logic input.
To input the logic signal, connect the GND of the target to the GND of the logic input.
A 4ch logic signal can be input at once.
Pins used for logic input.
No. Name
1 DGND
2 DGND
3 D1
4 D2
5 D3
6 D4
Spec. of logic input
Input voltage (can be specified from 0 to 5V by application)
Sampling frequency
Maximum input voltage
Copyright © 2012-2014 Heartland. Data Inc.
Description
Connect to the target GND
Connect to the target GND
Input for the D1 signal
Input for the D2 signal
Input for the D3 signal
Input for the D4 signal
Name MIN. TYP.
100
- 21 -
DT10 Hardware Manual
MAX. UNIT
5 V
MHz
5.5 V