Uplift Desk 2-Leg Height Adjustable Standing Desk Assembly And User Instructions Manual page 8

6. PROGRAMMING (continued):
CONSTANT-TOUCH & ONE-TOUCH
These steps allow the desktop to be set to either One-Touch or Constant-Touch. One-Touch requires
only a single touch of the "1, 2, 3, or 4" button to move the desktop to a preset memory location. One-
Touch is the default setting. Constant-Touch requires a continuous touch of the "1, 2, 3, or 4" button to
move the desktop to a preset memory location.
Change between One-Touch and Constant-Touch:
l. Press the DOWN button until the desk reaches the lowest position.
2. Press the DOWN button again until display flashes "RST".
3. Press the "1" button until display shows "10.1" (One-Touch) or "10.2" (Constant-Touch)
and goes back to "RST".
Note: While "RST" is still flashing, you can press the "1" button as many times as you'd like
to toggle between the two settings.
4. Press the DOWN button until the desktop lowers slightly, then rises slightly and the display
changes back to the numeric height setting.
MINIMUM & MAXIMUM HEIGHT SETTINGS
The desk frame ships defaulted to its minimum and maximum height limits. These steps allow the
upper and lower limits to be adjusted to your preference.
To Set a new maximum desk height:
l. Press the UP or DOWN button to move the desk to the desired maximum height.
2. Press the "M" button once, and then the UP button once. The Display will flash "S-"
3. Press and hold the "M" button until the Display shows "999",
and then changes to numeric value of new upper limit.
To Set a new minimum desk height:
l. Press the UP or DOWN button to move the desk to the desired minimum height.
2. Press the "M" button once, and then the DOWN button once. The Display will flash "S-"
3. Press and hold the "M" button until the Display shows "000"
and then changes to numeric value of new lower limit.
Removing adjusted maximum and minimum heights:
l. Press the "M" button (the display will show "S-").
2. Press the "M" button again until the display shows "555"
and changes to the current numeric height setting.
Note: If memory settings were previously set outside of the new minimum and maximum height
settings, they will default to the new minimum and maximum settings. To set new minimum and
maximum height settings outside of the current settings, you will need to first remove the current
minimum and maximum settings.
DISPLAY UNITS
Change the numeric display to show heights in either inches or centimeters.
l. Press the DOWN button until the desk reaches the lowest position. Release button.
2. Press the DOWN button until display flashes "RST".
3. Press the "2" button until display shows "10.3" (centimeters) or "10.4" (inches) and goes
back to "RST".
Note: While "RST" is still flashing, you can press the "2" button as many times as you'd like
to toggle between the two settings.
4. Press the DOWN button until the desktop lowers slightly, then rises slightly and the display
changes back to the numeric height setting.
8
© UPLIFT Desk • 1-800-349-3839 • info@upliftdesk.com • www.upliftdesk.com