Data Logging - ElectroFlip iTrack 2.0 User Manual

Make sure to wait for the reply then call the tracker to listen to sounds/conversations near the tracker.
To switch back to track mode (default mode) to get GPS coordinates, send a text message
containing:
Message Format: tracker+password
Text Message/Command: tracker123456
Reply: tracker ok

DATA LOGGING

The tracker automatically logs tracking position and alerts to its built-in 1MB flash memory (can save
about 16,000 positions) whenever GSM signal is lost or when tracker fall offline from GPRS. When
GSM signals get back, all event alerts will be auto-sent to the authorized numbers. For GPRS, once online
you would need to load the logged tracking data to the GPRS server via text message. See Data Load
for instructions.
You can also set the tracker to log tracking data at a particular interval. To setup this feature, send a
text message containing:
Message Format: save+intervals+time+tracking times+n+password
Text Message:
save030s005n123456 Reply: save
ok
NOTE: The example above shows that the tracker will log the latitude and longitude locations
every 30 seconds for 5 times. For time, you can set it to second (s), minutes (m), and hours
(h).
For multiple logging, send text message to the tracker containing:
Message Format: save+intervals+time+***n+password
Text Message: save030s***n123456
Reply: save ok
To clear the logs, send a text message containing:
Message Format: clear+password
Text Message: clear123456
Reply: clear ok
This document is a property of ElectroFlip LLC (www.ElectroFlip.com).
No unauthorized reproduction is allowed.
13