ICP DAS USA ICP CON GW-7557 User Manual page 29

the below:
Command 1 module parameters：
Channel Number：Channel 2
●
Device Number：Device 0
●
Output Mode：Polling
●
Example 2:
If the user wants to enable burst mode and read primary variable by using burst
mode. HART slave device connects with HART channel 3 of GW-7557, preamble
length is 5、long address is 0xFB 0x01 0x00 0x12 0x67, network type of HART
channel 3 is point to point.
In this case, the user should select the following modules:
1. Transparent mode：
The user can select a "8 Words Output module" and a "8 Words Input module".
2. Compact mode：
The user can select a "Command 108 module"、a "Command 109 module"
and a "Command 1 module" , module parameters are shown in the below:
Command 108 module parameters：
Channel Number：Channel 3
●
Device Number：Device 0
●
Output Mode：Manual
●
Command 109 module parameters：
Channel Number：Channel 3
●
Device Number：Device 0
●
Output Mode：Manual
●
Command 1 module parameters：
Channel Number：Channel 3
●
Device Number：Device 0
●
Output Mode：Burst
●
PS：
a. Channel Number：This parameter will decide HART channel of HART
GW-7557 PROFIBUS/HART Gateway User Manual (Version 1.00, Dec/2011) PAGE: 29