Hardware Overview; Front View - D-Link DCH-S150 Quick Installation Manual

HARDWARE OVERVIEW

FRONT VIEW

Motion Sensor
WPS
Reset
Power/Status
LED
Motion
Sensor
4
Blinking Green
Solid Red
Solid Green
Blinking Green
(slow)
Blinking Green
(fast)
Blinking Orange
Solid Red
Off
PIR (Passive Infrared) sensor for detecting motion.
Press for one second to start the WPS
connection process. The Power/Status
LED will start to blink green.
Press and hold until the Status LED turns
red in order to reset the device back to
the factory default settings (for about 10
seconds).
The DCH-S150 is successfully connected
to your network.
The WPS process is in progress.
The sensor is detecting motion.
The Motion Sensor is not properly
connected with your wireless network.
The Motion Sensor is powering on,
attempting to upgrade firmware, or the
device is defective.
If the DCH-S150 will not power on, try
plugging the device into another outlet.
Power/Status LED
WPS Button
Reset Button
DCH-S150