Hardware Overview - D-Link DCH-S161 User Manual

Section 1 - Product Overview
2
Action Button/LED
1
Water Sensor Probe
1 Water Sensor Probe
2 Action Button / LED
3 Reset Button
4 Siren
5 Battery Compartment
6 Mounting Holes
7 Battery Cover Release Tab
8 Water-Sensing Probe Port
D-Link DCH-S161 User Manual

Hardware Overview

Front
3
Reset Button
4
Siren
Place this in the location where you would like the sensor to detect water.
Press this button to complete WPS pairing. Press to turn off siren. Press to wake up device from sleep
mode. See LED Behavior on page 4.
Press this recessed button down quickly with a paperclip to reset the device to factory default settings.
The LED will flash red once.
Speaker for the 90 decibel siren.
Where 2 AA batteries must be placed to power the device.
The 2 holes where appropriately-sized screws can be placed in order to mount the device.
Press down from the top and pull out the battery cover from here.
Where to plug in the cable for the water-sensing probe.
Battery
5
Compartment
Bottom
8 Water-Sensing Probe Port
Back
6 Mounting Holes
Battery Cover
7
Release Tab
3