Table of Contents
Advertisement
Getting Started
Your first 10 minutes with the N9330B
3 Fasten the SHORT end of the T-combo to the RF OUT
connector, then press [ENTER] to initiate the short
calibration.
4 Fasten the LOAD end of the T-combo to the RF OUT
connector, then press [ENTER] to initiate the load
calibration.
To abort a calibration, press the [ESC/CLR] button.
For more details of calibration, please refer to
"Calibrate the N9330B before making
measurements" on page 25
Step 4. Connecting DUT to RF Output port
Example: Measuring return loss
After you have completed the calibration procedure
above. Refer to the following instructions to make a
return loss measurement.
• Connect the cable under test to the RF OUT
connector on the top panel of the tester.
• The tester immediately performs the measurement
and displays a trace on the screen.
If further data analysis is necessary, refer to:
"Using Markers and Pass/Fail Limit
Lines" on page 40
Traces" on page 43
20
.
"Processing
,
.
Advertisement
Table of Contents
