Table of Contents
Advertisement
Getting Started
Your first 10 minutes with the N9330B
Step 1. Selecting a measurement mode
Pressing [MODE] brings up a check box for you to choose
a measurement mode from the following five modes:
• SWR (Standing Wave Ratio)
• Return loss vs. Frequency
• Cable loss
• DTF-SWR
• DTF-Return loss
• Power Meter
Example: selecting the return loss measurement
1 Press [MODE] to bring up the mode selection check
box
2 Use the rotary control knob to select the Return Loss
vs. Frequency
3 Press [ENTER] to confirm your selection.
A measurement mode indicator – FREQ-RL will be
displayed in the top middle part of the screen.
See
page 24
Step 2. Setting a measurement range
Pressing [FREQ/DIST] brings up a submenu for setting
the measurement range.
If you previously chose a frequency domain
measurement, the submenu allows you to set the start
and stop frequency, or select a pre-defined frequency
range from the list of signal standards.
If you previously chose a DTF measurement, the
submenu allows you to set the start and stop
displayed distance, and other cable measurement
related parameters.
18
"Selecting a Measurement Mode" on
for more information.
Advertisement
Table of Contents
