Display Radio; Introduction; Button Description; Operating Status - Moretti Design AQUA User Manual

DISPLAY RADIO

Introduction

The display radio (black) is a wireless device for the stove
to which it is associated with and through it, it is possible
to control and monitor the systems functions in real time.
The main features are:
- Battery powered remote control.
- Room thermostat.
- Control device for the operating parameters.
Warning: The system works by using the 433.92 MHz ISM radio band
frequency. The range of the device can be reduced significantly in the
case of a noisy environment: other appliances such as wireless
headphones, video, etc, may affect the performance of the system. Make
sure of the presence of such appliances and turn them off or limit their
use. In the case of interaction of multiple remote controls with more
stoves, one must associate each display radio with a specific stove (see
"Code change" page 13).
The display lights up when the
screen appears.
Data e Ora corrente
Time and Date
Mer 14:26
Mon 14:26
Attivazione Crono
Chrono Activation
Temperatura Ambiente
Room Temperature read
rilevata dal radiocomando
by the Remote control 1 8°
Selected Fuel
Modalità di funzionamento
Pellet
(Not used)
Potenza di combustione
Combustion power
Temperatura acqua caldaia (°C) Boiler temperature (°C)
TW: 50 °C
button is pressed and the main
Livello carica batterie
Battery charge level
Codice Errore
Error Code
G Er02
Stato di funzionamento

Operating status

Spento Off
sistema
Remote control Room Termostato Ambiente
Radiocomando
Thermostat
20°
Modalità di funzionamento
Functioning mode
(Estate o Inverno)
(Summer or Winter)

Button description

Function
Button
Pressing the button when the main screen is
active, the device will continue to function
Sleeping
but will "fall asleep" thus reducing the battery
Mode
consumption. To turn the remote control
back on again, press again the button.
Pressing the button for 3 seconds from the
main screen, it is possible to turn off the
transmitter thus reducing battery
Standby
consumption. This feature is to be used
Mode
during a non use period of time of the
display radio. To turn on again press the
button again and press twice the
Switch On/Off by pressing the button for 3
On/Off
seconds
Unblocks the system by pressing the button
Unblock
for 3 seconds
ESC Esc Exit from menu
Power
Power setting when not in menu
Setting
Scroll Menu
Scroll through menu and submenu, increase
and
and decrease values
Submenu
SET Set Enter submenu, modify values, save data
Battery charge level (4 X AA - 1,5V)
Battery
charge level
full
Battery
charge level
at 2/3
Battery
charge level
at 1/3
OPERATING STATUS

Check Up

This phase begins as soon as the On/Off button is pressed. During this
phase, the system performs a cleaning process of the burner by running
the exhaust fan at maximum speed and simultaneously checking the
probes and safety devices.

Ignition

After the Check Up phase has been completed, the system goes to
Ignition. The auger loads a quantity of pellets into the burner and the
ignition resistance is activated. The system waits until the combustion
begins, then it starts to load small amounts of pellets in order to raise the
temperature of the fumes.
Description
button.
The batteries are flat;
replace them as soon
as possible.
The figure starts
flashing.
9