Setting Up And Using Tiway In 505 Softshop - Siemens SIMATIC 505 User Manual

505 SoftShop for Simatic 505
•
Number to Dial: Specifies the phone number to be dialed.
The number format can be dash (414-358-8088), space
(414 358 8088), period (414.358.8088), or none
(4143588088). Commas (,) may be used if a pause is
needed to gain access to an outside line before the number
is dialed. For example, if 9 is used to gain access to an
outside line and there is a pause between the time 9 is
pressed and a dial tone, then the number entered should be
9,414-358-8088.
3. Click OK or press Enter to accept the settings. Click Cancel to
disregard changes and return to the Communications Setup
dialog box.

Setting Up and Using TIWAY in 505 SoftShop

There are two versions of the host adapter hardware for TIWAY:
TIWAY I Host Adapter and UNILINK™.
NOTE Since the Network Interface Module (NIM) does not support
some task codes when the controller is in run mode, you cannot perform
the following functions communicating through a NIM: Force/Unforce
and Find (except Find Address).
Setting Up the TIWAY I and UNILINK HOST Adapters
To communicate with 505 SoftShop, the TIWAY I Host Adapter or the
UNILINK Host Adapter must conform to the following parameters:
•
NITP protocol
•
Full duplex
•
Asynchronous
•
Maximum Host Baud Rate: 19,200
See your UNILINK Host Adapter User Manual for details on setting dip
switches for the UNILINK Host Adapter.
TIWAY Setup Configuration
1. From the Communications Setup dialog box, click the TIWAY
button.
Result: The TIWAY Setup dialog box appears (Figure 4.4).
Figure 4.4
Secondary Addresses
1. From the TIWAY Setup screen dialog box, click the ADD
button to enter a new controller secondary address, or the
Modify button to change the controller secondary address
information.
Result: The TIWAY Path dialog box appears (Figure 4.5).
Figure 4.5
2. Enter the controller secondary address for the associated
controller. A controller secondary address is a unique number
4 - 505 SoftShop Setup • • • • 53