Download Print this page
Go Power GP-DC-KIT2 Owner's Manual

Go Power GP-DC-KIT2 Owner's Manual

Dc install kit

Advertisement

Quick Links

Go Power! DC Install Kit
Owner's Manual
1. Warnings
Avoid all electrical hazards. Disconnect batteries and electrical system from 120/240
VAC, or any other power source of electrical power, before attempting to install your Go
Power! GP-DC Install Kit.
Observe proper polarity throughout the installation process.
Work safely. Do not wear jewelry when working with electrical or mechanical equipment.
Use protective eyewear, gloves and apron when working with batteries.
Follow the safety precautions of the battery manufacturer. Do not produce sparks
when working in locations where flammable gases or vapors exist. Shield skin and eyes
from battery acid. If skin, eyes or clothing comes in contact with acid rinse thoroughly
with water.
Avoid electrical shock. Make sure all sources (inverter, shore power, generator) are
disconnected.

2. Installation Overview

Congratulations on becoming the owner of a GP–DC Kit. Please read and understand all
instructions before installing your new product for the easiest and safest installation.
Before installing kit, review the installation design with this DC kit Installation Manual.
Contact your Authorized Go Power! Dealer if in doubt as to this kit's suitability or
compatibility with your system. Retain this guide for future reference.
2.1 Disclaimer of Liability & Warranty
The conditions or methods of installation, operation, use and maintenance of this kit and
its solar module are beyond the control of Carmanah Technologies Corp. Carmanah
does not assume responsibility and expressly disclaims liability for loss, damage, or
expense arising from, or in any way connected with such installation, operation, use, or
maintenance. Carmanah does not cover labor or shipping for items returned.
3. Installation
1. The inverter fuse is to be mounted on the positive cable near the battery.
2. Cut the positive (red) cable according to desired location. Strip ½" to ¾" of
insulation from the cables, and connect the fuse block as shown.
Technical Support: info@gpelectric.com
Toll Free (US & Canada): 1-800-667-6527
Toll Free Fax: 1-866-607-6527
53498

Advertisement

loading
Need help?

Need help?

Do you have a question about the GP-DC-KIT2 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Go Power GP-DC-KIT2

  • Page 1: Installation Overview

    Before installing kit, review the installation design with this DC kit Installation Manual. Contact your Authorized Go Power! Dealer if in doubt as to this kit's suitability or compatibility with your system. Retain this guide for future reference.
  • Page 2: Specifications

    Go Power! DC Install Kit Owner’s Manual 3. Tighten the lugs to 10 ft. lbs. 4. Observe the polarity of the cables (red = positive) (black = negative) and connect accordingly to the inverter. 3.1 Installation Diagram Battery Fuse Block GP Inverter 4.

This manual is also suitable for:

Gp-dc-kit3Gp-dc-kit4Gp-dc-kit5