Mira Sprint 7.5 Installation, Operation, Maintenance Manual page 15

1.10. Drill and plug the top two fixing holes. Secure the Mira Sprint to the wall with the
screws provided. Drill the bottom fixing hole with the product in place.
Alternative fixings (not supplied) may be necessary for some wall structures.
Avoid drilling into any supply cable/pipe.
1.11. Install the mains-fed cold water supply pipe.
Terminal Block
Electrical Supply
Cable
Inlet Connector
Assembly
(The inlet connector
assembly can be
swivelled to suit the
supply)
Cold Water
Supply Pipe
Installation of the Mira Sprint
Holes For Cover
Retaining Screws
Fixing Screw
Splash Guard
(Make sure that it is secured
before operating the shower).
Do not fit the Mira Sprint to
the wall and tile up to the
case. The Mira Sprint must
be fitted on to a finished flat
and even wall surface (small
pillars moulded on to the
back of the case allow air
circulation).
Service Tunnel
(The service tunnel
or case may be
trimmed to suit rising
or falling supply)
Cover Retaining
Screw
15