Important Safety Information - Mira Sprint 7.5 Installation, Operation, Maintenance Manual

Section
2
1. Warning!
1.1. Products manufactured by us are safe and without risk provided they are installed,
used and maintained in good working order in accordance with our instructions and
recommendations.
1.2. THIS MIRA SPRINT MUST BE EARTHED.
1.3. In accordance with 'The Plugs and Sockets etc. (Safety) Regulations 1994, this
Mira Sprint is intended to be permanently connected to the fixed electrical wiring
of the mains system.
1.4. DO NOT twist the individual cable cores of the live and neutral conductors, as this
will prevent them from entering the terminal block.
1.5. Make sure that any pipework that could become frozen is properly insulated (Bye-
law 49).
1.6. DO NOT operate this Mira Sprint if it is frozen. Allow the Mira Sprint to thaw before
using again. The shower unit must not be fitted where it may be exposed to freezing
conditions.
1.7. If water leaks from the pressure relief valve, maintenance will be required before
the Mira Sprint can be safely used.
1.8. DO NOT fit any form of outlet flow control as the outlet acts as a vent for the tank
body. Only Mira recommended outlet fittings should be used.
1.9. There are no user serviceable components beneath the cover of the Mira Sprint.
Only a competent tradesperson should remove the cover.
1.10. If any of the following conditions occur, isolate the electricity and water supplies
and refer to "To contact us", on the back page of this guide.
1.10.1. If the cover is not correctly fitted and water has entered the Mira Sprint
case.
1.10.2. If the case is damaged.
1.10.3. If the Mira Sprint begins to make an odd noise, smell or smoke.
1.10.4. If the Mira Sprint shows signs of a distinct change in performance,
indicating a need for maintenance.
1.10.5. If the Mira Sprint is frozen.
4

Important Safety Information