Configuring The Transmitter; Figure 29: Hmi Navigation - ABB 266 MODBUS User Manual

Configuring the transmitter

The following sections provide instructions for configuring the transmitter.
Navigating the HMI menu
When using the local HMI interface, the display screen and soft keys are used to move around the menu, identify selections,
and perform actions. Figure 29 identifies each soft key and the associated action.
1
4
IMPORTANT NOTE: To navigate the menu, submenu, and available selections listed on a screen, the up soft
key will take you to the end of the selections list. When navigating to the last item of a list, it is faster to use the
up soft key to jump to the end of the list, versus using the down soft key to move through the entire list of
selections to reach the end or nearly the end.
Throughout this document, HMI navigation instructions will use abbreviated instructions to identify menu selections rather than a
more detailed style that identifies each key to press for each selection. The following example demonstrates the abbreviated
instruction which uses the greater than character (>) as an indicator that the following item is an additional menu selection.
Example of abbreviated instruction:
1. Press the right soft key to access the HMI menu.
2. Use the key pad to locate and select Calibrate > Diff. Press. Sensor > Calibration Units > Edit.
3. Scroll through the menu for the desired calibration unit selection and select OK when finished.
34 | 266 MODBUS® multivariable transmitter User manual 2105216 Rev. AB
ID Soft key
1 Left soft key
2 Up soft key
3 Right soft key
4 Down soft key
5
5 LCD screen
2
3
1

Figure 29: HMI navigation

4 Transmitter start up
Functionality
Perform action (Select), Exit, Edit, or Back
values from lists
Scroll up the menu and select values from
lists values from lists
Perform action (Select, Exit, Edit, or Back
values from lists
Scroll down the menu and select values
from lists
4
3
2