AEG BPK722910M User Manual page 37

37 www.aegaustralia.com.au | www.aegnewzealand.co.nz
WARNING! Do not use harsh
abrasive cleaners or sharp metal
scrapers to clean the oven door
since they can scratch the surface,
which may result in shattering of
the glass.
Positioning the door for dismantling
The door needs to be positioned at an
angle to aid in the disassembly of the
panes.
• Open the door fully to gain access to the
hinges.
• Push down the hinge locking tab on both
hinges.
Locking tab up - normal position
• Gently close the door until it stops in the
partially open position on the locking tab.
NOTE: The door cannot fully close
Locking tab up - normal position
with the locking tab in this down
position.
Removing the top door trim
• Push in the 2 tabs on either side of
the trim.
• Lift the trim away from the door.
Removing the glass panes
• Remove the inner glass and middle
glass layers from the door.
Locking tab down - for cleaning
Locking tab down - for cleaning
Inner Glass
• Clean the glass using detergent and
warm water. Wipe clean and dry
thoroughly.
• The outside glass cannot be removed
from the door and hence can be
cleaned in-situ.
Middle Glass x 2
Outside_
Reassembling the glass panes and
top door trim
• Replace the middle glass back to the
door first. The middle glass is a clear
pane and orientation of the glass is not
important.
• Replace the inner glass next ensuring the
side that is painted is facing away from
the oven cavity.
• Replace the top door trim ensuring
the 2 side tabs have clipped into the
column.
• Pull the hinge locking tabs back up and
close the door.
WARNING! Make sure that the
glasses are inserted in the correct
position otherwise the surface
of the door may overheat.
Light glass can be removed
- turn anti-clockwise
Inner Glass
Light glass can be removed
- turn anti-clockwise