Table of Contents
Advertisement
C
Electrical Power
This 3D printer uses an AC adapter with an output of 12 VDC, and an input of 110 or
240 VAC, 50/60 Hz. Ensure that your electric outlets provide power in this range.
- Do not allow anything to rest on the power cord. Do not locate this product where
people will walk on the cord.
- If an extension cord is used with this product, ensure that the total ampere rating of the
equipment plugged into the extension cord does not exceed the extension cord's
ampere rating. Also, ensure that the total rating of all products plugged into the wall
outlet does not exceed the fuse rating.
- Do not overload a power outlet, strip, or receptacle by plugging in too many devices.
- Use the product only with the supplied power supply cord set. If you need to replace
the power cord set, make sure that the new power cord meets the following
requirements: detachable type, UL listed/CSA certified, VDE approved or its equivalent,
4.5 meters (15 feet) maximum.
-
In case of malfunction, immediately unplug the printer from the power source.
-
Do not attempt to fix this product by yourself, as opening or removing covers may
expose you to dangerous voltage points or other risks. For service, contact
Monoprice Technical Support at tech@monoprice.com
Unplug this product from the wall outlet and refer servicing to qualified service personnel
when:
- The power cord or plug is damaged, cut, or frayed.
- Liquid was spilled into the product.
- The product was exposed to rain or water.
- The product has been dropped or the case has been damaged.
- The product exhibits a distinct change in performance, indicating a malfunction.
- The product does not operate normally after following the operating instructions.
- Keep the printer out of the reach of small children.
Disposal instructions
To minimize pollution and ensure utmost protection of the global environment, dispose of
this product only in accordance with local, state, or Federal regulations for the disposal of
electronic waste.
6
Advertisement
Table of Contents
