Table of Contents
Advertisement
S
S
UPER
ERVER 5038MR-H8TRF User's Manual
VGA Enable
JPG1 allows the user to enable the
onboard VGA connector (through
the KVM). Close Pins 1-2 to use
this function. The default setting is
Enabled.
Watch Dog
Watch Dog (JWD1) is a system
monitor that can reboot the system
when a software application hangs.
Close pins 1-2 to reset the system if
an application hangs. Close pins 2-3
to generate a non-maskable interrupt
signal for the application that hangs.
Watch Dog must also be enabled in
the BIOS.
Manufacturing Mode
Close pins 2 and 3 of jumper JPME2
to bypass SPI flash security and
force the system to operate in the
Manufacturing Mode, allowing the
user to flash the system firmware
from a host server for system setting
modifications.
BIOS Recovery Enable
Close pins 2 and 3 of jumper JBR1 for
BIOS recovery. The default setting is
on pins 1 and 2 for normal operation. .
VGA Enable/Disable
Pin#
1-2
2-3
Pin#
1-2
2-3
Open
Manufacturing Mode
Jumper Settings
Pin#
1-2
2-3
BIOS Recovery
Jumper Settings
Pin#
1-2
2-3
5-16
Jumper Settings
(JPG1)
Definition
Enabled (Default)
Disabled
Watch Dog
Jumper Settings
Definition
Reset (default)
NMI
Disabled
Definition
Normal (Default)
Manufacturing Mode
Definition
Normal
BIOS Recovery
Advertisement
Table of Contents
